![]() The parameter IPWLMask determines the subnet-mask for the This parameter is not available on STAR devices. The parameter IPWLAddress determines the IP address, which isīound to the wireless interface (an IP address from the local area The parameters IPSerMask determines the subnet-mask for the The parameter IPSerAddress determines the IP address, which isīound to the X.21-interface (an IP address from the local area IP network bound to the Ethernet interface. The parameter IPEthMask determines the subnet-mask for the The parameter IPEthAddress determines the IP address, which isīound to the Ethernet interface (an IP address from the local Packages are to be sent, whose target is not situated in the configured local area network and thus is not known in this network The parameter IPDefaultGW determines, to which IP address IP (10x2) data cables (between hybrid cables 2 and 3), since the Cline of the DTE is not been transferred here. Latter adjustment is particularly necessary with the application of 10paired C with X.21) or whether the signal is set internally by the (SerControl normal) on the synchronous serial interface NRZ is for No Return zero and NRZI for NO Returnĭetermines whether the external control signal is analyzed It can be selected between the values NRZ or The parameter SerEncode determines the coding procedure on The parameter SerCRC determines the error correction procedure that can be used (check total of 16 or 32 bits). The parameter SerBaudrate determines the Baud rate for the The following parameters serve for the configuration of the serial data interface and are important for correct data exchangeīetween the Router and the WIMAN radio data modem. Supposed to follow the data bits on the serial RS-232-interface. The parameter ConStopBit determines, how many stop bits are The parameter ConParity determines the type of the parity The parameter ConPauseMode determines if the output on theĭisplay shall be stopped after the number of lines given with The size of an output page is thus finally determined. The parameter ConPageSize indicates, how many lines in the respective command line window (terminal window over RS-232interface) are to be represented, before the continuous output of With software-controlled handshaking the control sequences It can be selectedīetween a software-controlled handshaking and no handshaking. Mode during a transfer on RS-232-interface. The parameter ConHandShake determines the handshaking When transferring data over the RS 232-interface. The Parameter ConDataBit determines the length of the data bits The parameter ConBaudrate determines the Baud rate that canīe transferred over the RS-232-interface for configuring the Serial configuration interface and are important for the correctĬommunication with the command line level. The following parameters serve for the communication with the Parameter for the Serial Configuration Interface The parameter Location can be edited freely to determine the location of the IWMAN radio modem, e.g. The parameter MaxNodeId determines the maximum number of
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |